Clicky driver's side CV - again! Options.

**ozscott** · 5th August 2016, 08:15 AM

Ok My D2 has taken down CV's all its life. At 290,000k I got another one, driver side, but this time I went a very low k (40-60k) second hand jobby to keep costs down. This one was quiet and in 10,000k has become clicky. Driver's side go first in my experience.

I dont want to go to the expense of Ashcroft so any suggestions. Just go new OEM?

I think part of the problem is that I run 31 inch tyres and its a manual V8 - so its getting a harder time. I have had the 4.6 in for the last 10,000k also so even more torque going through the CV and half shaft.

Cheers

**Pedro_The_Swift** · 7th August 2016, 08:00 AM

I did a quick count at Cooma and the ratio was ten to one,, V8's to rattlers, and I would guestimate the same for manuals of those V8's,,
so one in every hundred?
then add in the 4.6 and tall tyres and the odds start to get real long,,

are the RR CV's the same?

**weeds** · 7th August 2016, 09:10 AM

290k...i'd be happy with that and replace with OEM

**twr7cx** · 9th August 2016, 09:11 AM

Aside from the annoying noise, what is the detriment to driving on a clunky CV?

**weeds** · 9th August 2016, 04:31 PM

Originally Posted by twr7cx

Aside from the annoying noise, what is the detriment to driving on a clunky CV?

kaboom....i assume

**ozscott** · 9th August 2016, 07:46 PM

I wonder if my axle housing is out of alignment...will measure. Weeds I have done 3 in 290k...this would make it 4 in 300k...
Cheers

**Pedro_The_Swift** · 16th August 2016, 06:33 AM

and yes, kaboom is the worst result,, cage breaks.
The clicking is the cage crack opening and clicking shut.

Thread: Clicky driver's side CV - again! Options.

Thread Tools

Clicky driver's side CV - again! Options.

Bookmarks

Bookmarks

Posting Permissions