Thread: Centre console bling

I wouldn't do the centre in metal..
Will do a lovely job hacking someone's leg apart in a smash...

What about stuff rattling on it ?

Sent by iPhone using two tin cans and Forum Runner

Originally Posted by Tombie

I wouldn't do the centre in metal..
Will do a lovely job hacking someone's leg apart in a smash...

Tombie, you either have a very vivid imagination or you have been involved in some horrific accidents! You need to get a grip on reality or slow down mate.

Originally Posted by Tombie

I wouldn't do the centre in metal..
Will do a lovely job hacking someone's leg apart in a smash...

You have a point, it's bad enough getting splinters from the real wood on the ES in an accident .

Originally Posted by Fluids

What about stuff rattling on it ?

Sent by iPhone using two tin cans and Forum Runner

no problem you just put the original rubber pad over it .

Originally Posted by Ritcho

G'day everyone,
I m looking into getting the centre console parts in the attached photo laser cut from stainless steel, aluminum or black anodized aluminum checker plate! Laser cutting generally gets cheaper with volume, so is anyone interested?

I'm not sure if you know this, but you can get plastic and wood lazer cut. Perhaps you might like an aluminium finish plastic? Just thought i'd through it in there.

Originally Posted by Ritcho

Tombie, you either have a very vivid imagination or you have been involved in some horrific accidents! You need to get a grip on reality or slow down mate.

You have no idea what I've seen or experienced...

A sheet of stainless isn't a good idea...

There's a reason there's no exposed metal in the passenger compartment in modern vehicles..... plastic is less dangerous in a crash.