Electric brake controller install
I mounted it quite forward. By memory the screws are only about 1" behind the front of the dash. I used 8ga (or was it 10ga??) 25mm self tappers. They seemed to pull in quite firm. I didn't use double sided tape under the bracket as well as I'd run out. The bracket, with the screws right seem to pull them down into the dash & 'indents' to top of the dash somewhat.
You might have trouble getting a drill in there because of the windscreen. I used a metal tek screw with a stubby screwdriver to get the hole started then used the self tapper once done. Not sure if it's thin metal under or not but it seem to work.
I used the silver screws supplied to mount the P3 to the bracket. The window side with a Phillips head and the dash side with a spanner and a flat screwdriver to hold it firm while tightening with the spanner
Hope that makes sense
"Land Rover - making mechanics out of everyday motorists for nearly 70 years"
Bookmarks