Hi,
yes there are two - one each side, roughly same position, easy to see from below...
Are there 2 AC drain plugs? I only see one on Microcat on the drivers side.
Thanks
Julian
D2a Td5 Manual, Chawton White. aka "Daisy"
Build date 11th Oct 2003
Freelander 2 2011, manual, the daughter calls it Perri
Before I had a Land Rover I did not have any torque wrenches. Now I have three.
LROCV #1410
Hi,
yes there are two - one each side, roughly same position, easy to see from below...
Easy to open up from below?
D2a Td5 Manual, Chawton White. aka "Daisy"
Build date 11th Oct 2003
Freelander 2 2011, manual, the daughter calls it Perri
Before I had a Land Rover I did not have any torque wrenches. Now I have three.
LROCV #1410
Passengers side is up next to the auto
Here's some shots of my extended ones, used some inner hose from an old flexible hot water pipe like this Kinetic 300mm Flexible Water Connector | Bunnings Warehouse
Chopped the ends off and removed the outer braid then use some rtv silicone and glued them in after removing the duck bill and putting this on the extended end
Drivers side
Passenger side
Cheers Lemo
Julian , I removed the rubber fingers off the end as they are the cause of blockages when mud /dirts block them and extended the hoses and tied them up near the bottom of bell housing
I'll do something over the weekend. The smell of stale yucky water ain't nice.
D2a Td5 Manual, Chawton White. aka "Daisy"
Build date 11th Oct 2003
Freelander 2 2011, manual, the daughter calls it Perri
Before I had a Land Rover I did not have any torque wrenches. Now I have three.
LROCV #1410
D2a Td5 Manual, Chawton White. aka "Daisy"
Build date 11th Oct 2003
Freelander 2 2011, manual, the daughter calls it Perri
Before I had a Land Rover I did not have any torque wrenches. Now I have three.
LROCV #1410
Not too steal a thread but any reason why only my passenger one drips and not the drivers. I have checked for blocks with wire right up there, even looked under the dash and disconnected it and checked there too.
2000 Discovery 2 td5 Auto (Sandy)
2" dobinsons springs and bilstein shock,
Arb steel winch bar, homemade rear drawers,
steel rear bar
7" Led spotties, Roo systems awning, 3 cross bar roof racks
265/70R16 Falken Wildpeak AT3W
On balance I reattached the ends as I have heard stories on here of mud wasps etc building nests inside.Julian , I removed the rubber fingers off the end as they are the cause of blockages when mud /dirts block them and extended the hoses and tied them up near the bottom of bell housing
Just remember to clean them every now and then says he who has never cleaned them.( but I do look for pools under the car)
Regards Philip A
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks