Nanocom programmable fobs? Where to source?

Quote:

---

Originally Posted by reefmagnet

I had one win in that the vendor of the first fob has given me a refund. Feeling a bit guilty about that now [bigsad]

---

Well that's easily rectified!

Quote:

---

Originally Posted by johnp38

433 MHz from Sydney (ones they use themselves) LAND ROVER Key Discovery 2 Key complete Remote Key Ready for programming 433mhz | eBay

315 MHz from Overseas (ones I have for my Disco 2 programmed with my Nanocom) Keyless Remote Car Key Fob 315Mhz for Land Rover Discovery 1999-2004 N5FVALTX3 | eBay

---

So do both of these work?

Quote:

---

Originally Posted by d2dave

So do both of these work?

---

The 315 Mhz is the one that suits my D2 and yes works fine with 1.36b firmware on Nano. It is from overseas seller.

The 433 Mhz I bought before I knew the frequency of my receiver. It is sold by a bricks and mortar place in brisbane and they use them themselves. You can ring them 07 3252 7872 to confirm suitability for your application.

Post #10 and my experience confirms 315 Mhz units suit application.

Got a new key (433MHz) a week ago from Aussieremotes fleabay site,was getting ready to send it back to them after having issues with the sync and no luck on the key detect, saw this post and just went out and checked the firmware on the Evo which was 1.35.
Updated to 1.36b and it programmed first go!

Its odd though, in V1.35 I wrote the new key over the top of the original and it sync'd but wouldn't detect, I then tried to write the original key into slot 2 and it wouldn't detect either.
I then wrote the original key back into slot1 and it sync'd and detected perfectly... [wink11]

I've also noticed the touch senstivity of the screen is far better with this V1.36b update as well and Ive got the original Evo which has always been a bit hard to get a response on the keypress.

Cheers
Andrew