Thread: Do all cars have wiring for SLS?

Is it a 5 or 7 seater?

Five could be either,SLS was an option,most were coils though.
All seven seaters had SLS.

I think regardless of model, or level of trim, all shared the loom.
I believe there were differences between D2 and D2a, but each variant was was pre-wired for all options.

Yeah, I think what Ian said. Smartest thing LR did was use one loom in the D2. When I put the front bar on mine I put in fog lights, harness was there just needed a relay and switch in the appropriate position in the binnacle.

Originally Posted by Bohica

If not, what do I look for?

Thanks
Julian

It can be factory fitted with non-SLS harness then it misses all the wiring for the compressor assy and height sensors, if it's so C0391 doesnt have wires in pins 1, 3, 5, 6, 9, 10 or it's not connected at all if no ACE as well then 0377 is free and if you want to retrofit SLS you need a chassis harness for that, see the part numbers Genuine Harness-chassis For Land Rover Discovery 2 1998 - 2004 Classic | Jaguar Land Rover Classic Parts

Originally Posted by sierrafery

It can be factory fitted with non-SLS harness then it misses all the wiring for the compressor assy and height sensors, if it's so C0391 doesnt have wires in pins 1, 3, 5, 6, 9, 10 or it's not connected at all if no ACE as well then 0377 is free and if you want to retrofit SLS you need a chassis harness for that, see the part numbers Genuine Harness-chassis For Land Rover Discovery 2 1998 - 2004 Classic | Jaguar Land Rover Classic Parts

How annoying, I do not have a yellow plug at all, just an orange one, which I think may be C0377. Bugger!! I've ordered all the parts I may as well get the harness. This could change as I have not seen the price yet.
EDIT
Ouch 395 pounds and not available. The harness I am missing goes to the compressor and the ride height sensors? All I need to do is build on of those. Easy right? Or find one at a wreckers

Originally Posted by Bohica

The harness I am missing goes to the compressor and the ride height sensors? All I need to do is build on of those. Easy right? Or find one at a wreckers

Yes, the harness goes to the compressor assy for the pump's feed and the 3 valves and height sensors

I have a chassis loom lined up. I'll remove the SLS parts and re wrap and then run it along the existing loom. I'll put this on my YouTube channel and make millions. Or not
Actually a video recird is not a bad idea. Or photos.

mine is an 03 poverty pack,no loom.