Page 2 of 2 FirstFirst 12
Results 11 to 15 of 15

Thread: NOT 3 amigos - TC nd HDC bulbs do not illuminate ABS does

  1. #11
    Join Date
    Jul 2014
    Location
    west of Transylvania
    Posts
    3,783
    Total Downloaded
    0
    Quote Originally Posted by getLuke View Post
    Awesome mate. Will check this.

    I leant today I need to write the settings, so thats handy!
    Off course that there are some options where the "write settings" function is not at the end so dont try to find it there but dont miss it where it's necessary
    Discovery Td5 (2000), manual, tuned

  2. #12
    Join Date
    Jan 2019
    Location
    Sunshine Coast
    Posts
    61
    Total Downloaded
    0
    Quote Originally Posted by sierrafery View Post
    Off course that there are some options where the "write settings" function is not at the end so dont try to find it there but dont miss it where it's necessary
    Yep it was at the menu where instrument pack is.

    I owe you a 6-pack mate! It was all disabled so it’s now all good. I’m going to give it a flog to test TC and find a hill for HDC.

    I really appreciate your prompt responses!

  3. #13
    Join Date
    Jan 2019
    Location
    Sunshine Coast
    Posts
    61
    Total Downloaded
    0
    Update from yesterdays test:

    ABS light now permanently out ✅

    TC & HDC lamps all flash at ignition II lamp test ✅

    Took it on empty lot near me, gave it a good throttle and hard turn and TC operated when it should have ✅

    HDC will test this week when I have time.

    Only thing I did notice was the lamp ‘HDC!’ on. Amber lamp on the bottom LHS with vehicle angled down to the right with exclamation mark. It was on for a short drive then when parked and recycled ignition, it was gone.

  4. #14
    Join Date
    Jan 1970
    Location
    Melbourne, AU
    Posts
    839
    Total Downloaded
    0
    You don't need a hill to test HDC. Just put in low ratio, turn HDC on, accelerate (to > HDC speed) then take your foot off the gas. It should immediately kick in.
    _________________________
    1996 D1 V8 - gone
    2002 D2 Td5 ES- gone but still running elsewhere
    2013 D4 SDV6 HSE - gone
    2023 Defender 110SE D300

  5. #15
    Join Date
    Jun 2018
    Location
    Edenvale
    Posts
    10
    Total Downloaded
    0

    BCU settings read / write

    Quote Originally Posted by sierrafery View Post
    Go with nanocom in BCU - Settings - Instrument pack and check if the TRC and HDC were not accidentaly disabled there cos nanocom used to alter settings there without request, each time you use nanocom dont forget to "write settings" at the end then exit the menus, turn ignition off and disconnect it after 60 seconds
    I assume one reads the settings, then writes after checking them, without saving them to file first? I usually write/save settings to file then write them back from the same file again.

Page 2 of 2 FirstFirst 12

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!