I thought there was a setting that you could access on the Nanocom???
Printable View
I thought there was a setting that you could access on the Nanocom???
Yes, here it is. check this thread.
Enabling Daytime Run Lights and Courtesy Headlamps
Unfortunately EGR switch off is done in tune/remap or whatever you wanna call it.
Thanks all for asking a question and providing a solution before I have even had a use for it !
I have written it in my notebook and will go and tag the connector tomorrow for future use.
I thought you meant the egr delete when you mentioned nanocom after the EGR discussion my reply was about that not about the DRL activation... albeit enabling DRLs with nanocom won't work just like that, it needs a resistor, unless the vehicle is scandinavian or japan spec.
Cheers Simon, I've replaced the broken and tatty, original fog lights with aftermarket, high quality USA sourced units. They have come with two globes per lamp, I want to utilise the extra globe as a DLR, so will use Sierrafery's solution.
The lights were purchased as a direct replacement, no modifications needed. The only commonality or similarity to the originals, is the diameter of the lens being within 10mm of the Land Rover units.
I've had to fabricate bracketry incorporating adjustment on three planes. In typical time's running out fashion, it would appear ARB, when they manufactured the bull bar, owned neither a jig nor ruler, so consequently each side had to be designed individually.
It started as a ten minute job that took a day and a half!
Thanks John, busy's not the word. It's three steps forward then two steps back and just to make it interesting, I've put my back out.