I've just got hold of a 2nd hand safari snorkel to fit onto my D2 (my kids were insistent we get one!), there are a few bits missing of course.....

This forum has been amazing and I've already found the fitting template uploaded by 999 but I'm hoping I might get some help with a few other questions/bits.

1. I'm missing the air entry adapter (the bit that goes inside the front fender/wing), is this part plastic or metal and does anyone have one handy they would be able to get some measurements from for me (I'm considering knocking one up and 3d printing it)?
2. Does anyone have the inner template that is used to get the hole in the right place for the above air entry adapter?

I'm also missing the upper mounting bracket but I'm pretty sure I can work that one out, the grill on the air ram head part was also missing but I've managed to have a fiddle and 3d print a replacement.

PXL_20230413_235835243.jpg

Finally, the Safari instructions mention using a sensor safe sealant. Any recommendations on one which is easily available at Supercheap or Repco?

Thanks very much in advance!