Engine Immobilisation and Remote unlocking

Quote:

---

Originally Posted by shack

If you are referring to a 2nd hand D2 key not being able to be recoded to a different D2, that is not correct at all.

I do it all the time.

---

Aha!
apologies, I thought once coded, it's baked into the key. Good to know.

Quote:

---

Originally Posted by sierrafery

Which means that on your vehicle the "passive immobiiser" is disabled and the alarm disarm mode is on "Always"(always disarm with key), doable with nanocom not factory setting.

---

yep, for sure.
First thing I do to any new D2 that comes my way, disable the immobiliser via nanocom.
Had the episode with the brothers TD5 back in the day, not long after he got it, it immobilised itself due to low battery.
I think took 3 or so hrs to figure it all out, as we were new to D2 idiosyncracies at that stage. .. so vowed never again to be stuck like that.
EKA also coded to easy to input values too, just in case.
IIRC also set transponder to single push to unlock all doors, not just drivers door .. etc, etc.

So sounds like OP really needs to meet up with a nanocom owner, or else buy themselves one and set the D2 up for less hassles for security.

Quote:

---

Originally Posted by shack

If you are referring to a 2nd hand D2 key not being able to be recoded to a different D2, that is not correct at all.

I do it all the time.

---

Thanks for confirming that Shack.

I have now managed to buy a working (used) D2 original fob (Australian not US - so correct frequency). Next task will be to code this into the BCM... but I have yet to get a tool that will allow me to do this. Nanocom is mentioned in several posts....... is that the only tool that will do the job, or are there any others now ? (What are you using ?)

I am hoping to avoid spending a fortune on another tool that I will use infrequently. Been there, done that on Saab's and Rover 75's and none of them were any use really.

Thanks
Oldmowgli

Quote:

---

Originally Posted by Oldmowgli

Thanks for confirming that Shack.

I have now managed to buy a working (used) D2 original fob (Australian not US - so correct frequency). Next task will be to code this into the BCM... but I have yet to get a tool that will allow me to do this. Nanocom is mentioned in several posts....... is that the only tool that will do the job, or are there any others now ? (What are you using ?)

I am hoping to avoid spending a fortune on another tool that I will use infrequently. Been there, done that on Saab's and Rover 75's and none of them were any use really.

Thanks
Oldmowgli

---

I would use the nano.