4HP24 into DiscoII

Quote:

---

Originally Posted by Slunnie

Thanks Andy. Does that mean that the 22EH runs the same pump etc as the 24EH? I wondered this as they both run M18 cooler hoses instead of the M16 that the 22 uses.

Is there anything that would prevent the 24EH bolting straight up to the TD5 in that case, except with a TD5 torque converter? The transmission setup will be different of course.

---

I dont know, i havent measured the hose diameters, and scouse bought my hp24 so it isnt laying arond anymore. The output shaft is not removable on the HP24 (no bolt up the middle) and looks shorter than a 22eh. Might take a bit of stuffing around swapping bits, but the swap is definately do-able.

Andy

Well I have put the 4HP24 into my Disco II. Really not much need to be changed. I slightly oblonged the holes for the transmission mounts, but that was it. I had a Disco I transfer case shifter, which I could have reused, but I got a good deal on a '04 CDL lever and linkage. Seems to work well in my Rover.

Now I am thinking if it would hold up to a stock LS1.