NANOCOM P38 UNLOCK CODES

Thanks Paul. One thing I forgot to mention is that on my Nanocom the page where you select which vehicle has the Disco 2, the Puma and the Defender but there is no mention of the P38 and there is no second page where I assume the P38 would be. Would this only be loaded once the unlock codes are accepted?

Quote:

---

Originally Posted by NPEP

Thanks Paul. One thing I forgot to mention is that on my Nanocom the page where you select which vehicle has the Disco 2, the Puma and the Defender but there is no mention of the P38 and there is no second page where I assume the P38 would be. Would this only be loaded once the unlock codes are accepted?

---

No. It should be there even without the code.
Sounds like you need to do the firmware update to make sure you have the P38a support.
If you are seeing "kernel firmware 1.06" at start up your update revision is 1.04 or earlier this means the P38a support isn't loaded.

Once you have done the update once you'll find it is very simple to do.

Don't worry about enabling the overwrite settings config option. You don't need it. :D

Paul, I can't thank you enough. I did the upgrade (thanks for the instructions). When I went back into the Nanocom, the P38 was on the first page. I loaded the unlock codes PROPERLY this time and it saved them correctly.

I will have to wait until tomorrow to test on the vehicles

Thanks again
Neil:)

Not a problem. Glad you've got it sorted.

cheers
Paul