Printable View
I know what it is ,The bit with the taper would be to center the holder wich would be bolted down .The reamer would be used to recut seat .The black things are delrin? same OD as the cutter .Uses I don't know injector seats? steam? water valves? no prize but would like to know Delrin bits part of ? The bit with the holes is handle for reamer shaft
AM
Bump ( sorry Ian but Love that terminology)Quote:
Originally Posted by cuppabillytea
Chops appears to be so engrossed in Blowsie and enthralled with Wombat that he has forgotten he owes us a BLOODY MARVEL!!!!!!!!!:rulez::bat::bat::bat:
Here's something to whet the appetite.
Found this. I'm not exactly sure why it's used, but I know what I does. I'll accept the same rigor for the winning response.
Should be a quick one before chops comes back with a marvel in a week or so! [bigwhistle]
https://www.aulro.com/afvb/images/im...017/07/750.jpg
https://www.aulro.com/afvb/images/im...017/07/751.jpg
https://www.aulro.com/afvb/images/im...017/07/752.jpg
Locking wheel nut remover?
Negative.Quote:
Originally Posted by Fifth Columnist
Hi
Filter removal socket?
Cheers
Unfortunately not for filters.
The bottom part looks like it might fit over a gate valve handle, perhaps so a speed brace can be used on it?
I'll pay that.Quote:
Originally Posted by POD
It's a valve tool for gas cylinder valves.
https://www.aulro.com/afvb/images/im...017/07/759.jpg
Probably used to torque up the valves to a correct value after filling. 3/8 drive hole in the top of it, with grub screw.
Cast in Australia too!
Whatever happened to the simple old "C" spanner?
[EDIT] I suppose the why is that sometimes Gas valves need to be turned off from a safe distance, or behind a mist spray.:firedevil: