Thread: Ratchet crimping set recommendation

I've never owned a ratchet crimper that works as it should. I think the trick is you must have the right crimper that matches the crimp on connectors you have ..... and the exact sized wire and wire insulation that matches the crimper.

I dont think I've ever crimped a wire that I haven't been able to pull apart So I solder them A 12volt superscope would be more useful in the car toolkit than a crimper

seeya,
shane L

I have just about every crimp tool known to man, but for travelling and odd jobs I use a Channellock 908 crimp/ wire stripper tool. It looks like one of the cheap types you get in kits, but it cuts, strips, twists and crimps very well. Don't think it does non insulated crimps, but that's easy enough to live without.

Originally Posted by DoubleChevron

I've never owned a ratchet crimper that works as it should. I think the trick is you must have the right crimper that matches the crimp on connectors you have ..... and the exact sized wire and wire insulation that matches the crimper.

I dont think I've ever crimped a wire that I haven't been able to pull apart So I solder them A 12volt superscope would be more useful in the car toolkit than a crimper

seeya,
shane L

When I rewired the engine bay and more, with same colour code and gauge wire from a spare RRC loom, I soldered everything too.

No probs at all after 15+ years.

cheers, DL

For years and lots of them, I have always been a solder everything man.

However in recent times (last 2to 3 years) a lot of research on the interweb has suggested that crimping done properly is better.

Originally Posted by d2dave

For years and lots of them, I have always been a solder everything man.

However in recent times (last 2to 3 years) a lot of research on the interweb has suggested that crimping done properly is better.

Yes its much better. Its really a cold welded join as it is compressed so tight. This is if you own a factory where all your wire size is of a known standard, insulation sizing exactly matching the crimp on connectors you are using ..... which are being crimped by the exact crimping pliers that they require ....................................


Yep, lost me right away . The main thing with a soldered joint is to make sure its tied down. Any flexing allowed will break the wire beside the soldered joint. I've found soldering wires sucks as you need 4 hands to do a nice job. Recently someone pointed these out to me.

100 pcs/lot 0.5 1.5mm Crimping Button Cold Pressing Splice Electric Wire Terminal Connector Cable Lugs Sertir|Terminals| - AliExpress

I don't use them as crimp on connectors, I just use them to hold the wiring for soldering. You get a perfect joint you can put heat shrink over that way. I didn't realise the reason I was sometimes getting "solder spikes" was I wasn't using a eutectic solder. Though I don't tend to get solder spikes whne using the joiners as your not trying to juggle everything.

seeya,
shane L.

narva solder splice kit - Google Search solder splice - YouTube


What about these? I bought some but haven't had to use them yet, touch wood.