i need a bit of help.....

110 DIESEL from vin LA 930435 to vin LA 939975 FTC3905
110 DIESEL from vin MA 939976 to vin ZA 612404 FTC3905
110 DIESEL from vin 1A 612405 FTC3905

ftc1249 is the rear prop for 130 td5,

look here, takes a few to open.
http://www.bearmach.com/acatalog/Def...=%22RTC3346%22

cheers phil

thanks guys.....the original shaft that i broke.....has the part number FTC4198.....

the part i was sent is FTC3905......and its about 1 1/2 to 2 inches longer.....
it has written on it in white texta by the wreckers....defender '02 5 speed.....


i wouldnt have expected any difference between '02 and '03 either......
all that changed was that they fitted tie down loops in the cargo area...... :eek:

only thing i can think that might have happened is if your deefer has a sailsbury diff as opposed to a rover diff. the sailsbury is some 40mm longer in the pinion than the rover diff.

If the tail shaft is from a rover fitted deefer and your trying to put it on a sailsbury the shaft will look too long.

that makes sense.......

tony check closley near the welds at each ends of the shaft, should have the part number stamped in it?? just checked the 90's shafts, their stamped.

phil

I couldn,t find anything on mine. There was a white arrow on it pointing to the front but that was all I found.

spoke to carkraft today about it......they had no listing of it either.....
this is strange......



maybe someone with an '03 fender could take a look at theirs out of curiosity to see what they have.....

and make sure not to break it.....as it doesnt seem to exist......:eek:

Quote:

---

Originally Posted by DEFENDERZOOK

i need the part number on the rear tailshaft of a defender 130.....
and also a 110.....


along with the year of manufacture for the vehicle.....



reason.....?
i got a tailshaft sent out....its a different length to mine....
it also has different part numbers....its off a 2002 defender....
mine is 2003 defender......what has changed between these two years.....?

---

Sorry of no practical help here Tony, however, with an Avatar like you have, and an opening line "I need a bit of help...." one can not help but think Yes.

Quote:

---

Originally Posted by mr_sav

Sorry of no practical help here Tony, however, with an Avatar like you have, and an opening line "I need a bit of help...." one can not help but think Yes.

---

:D:D:D:D


This is quite the switch eh Tony,,,,
must be a million members on here who "owe" you a bit of help:p

Tony,
I've just checked with our parts guys.
FTC4198 is the shaft for your car (that's going by the VIN).