What would it cost to have the old bits swapped over to a new custom shaft? Plenty of places make them.
Ron
Printable View
What would it cost to have the old bits swapped over to a new custom shaft? Plenty of places make them.
Ron
Last time I got a quote, couple of years ago, it was $750 for a complete shaft for the 120".
Cheers,
Simon
Was that without using the old yoke and slip joint, i.e., all new parts?Quote:
Originally Posted by abaddonxi
If it used the old parts, that's pretty exxy. :eek:
Ron
That was all new from end to end. Still seemed pretty pricey to me.
Cheers,
Simon
forget the tailshaft....simon.....
where have you been hiding.....?
Hi Tony,Quote:
Originally Posted by DEFENDERZOOK
I apologise if it came out the wrong way, I was giggling when I wrote it. My apologies.
It was not meant in a sarcastic way, though I can see now that it may have come across that way.
It was late, and I should have mentioned below I was chuckling at the time.
Best Wishes.
its ok.....i know what you meant.....
i was laughing myself.....
this place is all about helping each other when you can.........
but you gotta have a laugh doing so.......otherwise might as well be on one of the other forums.....
PS....ran out of stamps.....bills will go out first thing monday morning.....