i need a bit of help.....

**p38arover** · 5th October 2006, 07:21 AM

What would it cost to have the old bits swapped over to a new custom shaft? Plenty of places make them.

Ron

**abaddonxi** · 5th October 2006, 08:10 AM

Last time I got a quote, couple of years ago, it was $750 for a complete shaft for the 120".

Cheers,
Simon

**p38arover** · 5th October 2006, 08:25 AM

Originally Posted by abaddonxi

Last time I got a quote, couple of years ago, it was $750 for a complete shaft for the 120".

Was that without using the old yoke and slip joint, i.e., all new parts?

If it used the old parts, that's pretty exxy.

Ron

**abaddonxi** · 5th October 2006, 08:54 AM

That was all new from end to end. Still seemed pretty pricey to me.

Cheers,
Simon

**DEFENDERZOOK** · 5th October 2006, 03:33 PM

forget the tailshaft....simon.....

where have you been hiding.....?

mr_sav · 5th October 2006, 04:37 PM

Originally Posted by DEFENDERZOOK

i try and help where i can.......but its not quite like that........i dont expect anything for it......
unless i ask.... ......

i will be sending out the bills this week.......!!

Hi Tony,

I apologise if it came out the wrong way, I was giggling when I wrote it. My apologies.

It was not meant in a sarcastic way, though I can see now that it may have come across that way.

It was late, and I should have mentioned below I was chuckling at the time.

Best Wishes.

**DEFENDERZOOK** · 5th October 2006, 04:48 PM

its ok.....i know what you meant.....
i was laughing myself.....

this place is all about helping each other when you can.........
but you gotta have a laugh doing so.......otherwise might as well be on one of the other forums.....

PS....ran out of stamps.....bills will go out first thing monday morning.....

Thread: i need a bit of help.....

Thread Tools

Bookmarks

Bookmarks

Posting Permissions