Cold Weld Epoxy
Went to offer up the starter motor back in place and the top l/h thread on the case is fuggered. Looks like someone has tried to drill out a stud or bolt at some point and failed miserably.Theres no thread left and its hard up against the side of the engine so i doubt i could get in a drill and re thread it.So was thinking would a Tube of cold weld be enough to hold a bolt in place with the main strain held on the bolt bottom r/h or am i wasting my money. Its only the bush basher, not intended for anything other than collecting wood.
Cheers,
d
1957 88 Petrol (Chumlee)
1960 88 Petrol (Darwin)
1975 88 Diesel (Mutley)
Bookmarks