Power to the rear D4

Quote:

---

Originally Posted by Graeme

The wiring diagram shows it as 2.5D. Other wires elsewhere on the vehicle (eg going to the suspension ecu) that are also shown as 2.5D have about a 2.5mm dia conductor, 1.5D have 1.5mm and 0.5D have 0.5mm diameter conductors.

A 20A load and a volt meter will do a better job at sorting it out as its length is unknown.

---

I measured it with my fridge attached and wrote it down somewhere - at the fridge it was something like 12.7V with the engine running (as I use the powered pin from the car). I'll see if I can find the exact figure.

Cheers,

Gordon

Was that running a 3-way or a compressor fridge?

Quote:

---

Originally Posted by Graeme

Was that running a 3-way or a compressor fridge?

---

Fridge as above - 170 ltr 3-way (with separate freezer)

Cheers,

Gordon

Quote:

---

Originally Posted by gghaggis

I measured it with my fridge attached and wrote it down somewhere - at the fridge it was something like 12.7V with the engine running (as I use the powered pin from the car). I'll see if I can find the exact figure.

Cheers,

Gordon

---

Just went down to the car to check my trusty notebook, and I'd logged the figures there. Not as good as I recalled :(

Engine running and 13.4V at the battery, I got between 11.9 and 12.1V at the fridge. The regime was to run the caravan fridge off the car during the day travelling, so never more than 9hrs at that voltage.

Cheers,

Gordon