-
3 Attachment(s)
If I buy a used one it is probably on its way out. If I buy a new one it is expensive. Anyway here is where I am at I will try to fix it and if I can not then I have to buy a one.
I got the glove box out using a casing from a pen and a small screw and pushed the pins out a very easy job. removing the small trims were scarier because I might break them taking them out.
OP talked about placing a metal pin does anyone have an idea does it go across both tabs at the glove box? and how is the handle installed is it just pushed into those tabs?
Attachment 194581
Attachment 194582
Attachment 194583
-
3 Attachment(s)
I glued it together for now and placed a paper clip to hold it in place. Maybe I will put a fabric or fiberglass that in place to give it more strength. It is so flimsy on that side. It is really better off as a RHD drive design because the sturdier side will be where it is being pulled if the driver sit on the RH side.
Attachment 194586
