Safari snorkel D4 - How/where does it fit

From memory, there are 5 holes in the A pillar mount and I drilled 4. At which point I dulled about 4 std drill bits and thought "That will do!" :D

Yes I remember going through a few bits, in the end I drilled a pilot hole first.

Yeah so I found out today, bought cobalt bits as advised. lasted 1 hole. Well I suppose off to Bunnings again tomorrow and at least 4 drill bits. What a joke. Anyone had any better luck with any particular type of bit? Cobalt, Tungsten, Diamond?

Quote:

---

Originally Posted by Redback

Yes, so be prepared for one drill bit per hole!!

Baz.

---

Just buy a drill bit per hole. It’s the simplest approach

Quote:

---

Originally Posted by sniegy

I have fitted a few of these.
The pipe work runs from the air intake grille on the rhs & in along a chanel built into the upper guard. Holes will need to be drilled, inner panels will need to be cut away too.
A plate is pop riveted to the "A" pillar which holds the upright section.

Sorry don't have pic's as I now have the LR RAI.

Cheers

---

Sneigy you wouldn’t happen to have a copy of the install templates for the Safari would you ?

Quote:

---

Originally Posted by landrovermick

Sneigy you wouldn’t happen to have a copy of the install templates for the Safari would you ?

---

Pete hasnt been on this forum since June 2020.

I have a copy of them here (somewhere). If i can find them, I'll try and scan them.

Quote:

---

Originally Posted by Tombie

Pete hasnt been on this forum since June 2020.

I have a copy of them here (somewhere). If i can find them, I'll try and scan them.

---

Mate I think I’m going to go with a new one the second hand one I was going to get needs to come out of a donor car in campbellfield