Thread: Safari snorkel D4 - How/where does it fit

Yes I remember going through a few bits, in the end I drilled a pilot hole first.

Yeah so I found out today, bought cobalt bits as advised. lasted 1 hole. Well I suppose off to Bunnings again tomorrow and at least 4 drill bits. What a joke. Anyone had any better luck with any particular type of bit? Cobalt, Tungsten, Diamond?

Originally Posted by Redback

Yes, so be prepared for one drill bit per hole!!

Baz.

Just buy a drill bit per hole. It’s the simplest approach

Originally Posted by sniegy

I have fitted a few of these.
The pipe work runs from the air intake grille on the rhs & in along a chanel built into the upper guard. Holes will need to be drilled, inner panels will need to be cut away too.
A plate is pop riveted to the "A" pillar which holds the upright section.

Sorry don't have pic's as I now have the LR RAI.

Cheers

Sneigy you wouldn’t happen to have a copy of the install templates for the Safari would you ?

Originally Posted by landrovermick

Sneigy you wouldn’t happen to have a copy of the install templates for the Safari would you ?

Pete hasnt been on this forum since June 2020.

I have a copy of them here (somewhere). If i can find them, I'll try and scan them.