Quote:
Originally Posted by ~Rich~
I can't seem to access / download the installation instructions. Just bought the kit and wanting to fit it to my 2015 LR4
Printable View
Quote:
Originally Posted by ~Rich~
I can't seem to access / download the installation instructions. Just bought the kit and wanting to fit it to my 2015 LR4
Hope this helps,Quote:
Originally Posted by Simeon Prucha
Than ks Mog60. I fitted it today to my LR4. Relatively easy but now getting suspension faults... :-(
Did you disconnect the battery before fitting? If not you might expect to see some faults occur. From memory some have said these will go after cycling the ignition a few times.
The following comes from the instructions:-
Reconnect the battery and switch on the ignition. A suspension fault may be shown if the battery was not disconnected,
in which case switch the ignition off then on to clear the message. If a fault message is still displayed then refit all
connectors.
Hope it sorts itself.
.
I've been in contact with Simeon regarding the faults. Something is amiss.
One of the ICs in the LLAMS module was faulty in a manner that I've not seen before which wasn't spotted during module checking even though it would have been showing on the oscilloscope.