D3 trailer hubs

Hi

So i dont want brakes. So i can just get some commodore hubs and drill them out to suit the 14mm stud and buy some land rover nuts to suit?

Stud size 14mm 1.5 pitch?

Thanks

Chris

Actually most trailer hubs can take different size studs without drilling - trailer studs are very often the same size splines for different size studs. Speak to your trailer parts supplier who can best advise - but I get it all to match the car if you were able.

Garry

That's the plan as i have 05 D3 with the 10 spoke alloys and i bought another set and will put them on my camper. thanks for your help. Will chat with the guys tomorrow.

Quote:

---

Originally Posted by garrycol

Actually most trailer hubs can take different size studs without drilling - trailer studs are very often the same size splines for different size studs. Speak to your trailer parts supplier who can best advise - but I get it all to match the car if you were able.

Garry

---

Not when going from 7/16 to 14mm, you need to drill the hole to suit the larger 14mm stud.

Quote:

---

Originally Posted by ctgiles84

That's the plan as i have 05 D3 with the 10 spoke alloys and i bought another set and will put them on my camper. thanks for your help. Will chat with the guys tomorrow.

---

Just make sure before you buy the hubs, test that centre boss on the hub fits into the centre hole of the D3 rim.

Baz.

Quote:

---

Originally Posted by Redback

Not when going from 7/16 to 14mm, you need to drill the hole to suit the larger 14mm stud.

---

I did say most - implying not all :)- however on the Commodore trailer brakes I purchased I was able to tap out the 7/16 studs and tap in the 14mm studs as they has the same size spline in the inside of the stud - we are talking studs made and provided for trailers and not studs supplied by Holden.

I never knew this until I went to the trailer place and had been looking at car studs (by the way genuine VE Commodore wheel studs are different front to rear but not sure of the reason - length maybe).

cheers

Garry

Quote:

---

Originally Posted by garrycol

I did say most - implying not all :)- however on the Commodore trailer brakes I purchased I was able to tap out the 7/16 studs and tap in the 14mm studs as they has the same size spline in the inside of the stud - we are talking studs made and provided for trailers and not studs supplied by Holden.

I never knew this until I went to the trailer place and had been looking at car studs (by the way genuine VE Commodore wheel studs are different front to rear but not sure of the reason - length maybe).

cheers

Garry

---

I might check out my spare hub, it's a commodore non braked hub with 7/16 studs(emergency spare for long trips) I know I had to drill out my disc braked hubs when I had them.

Baz.