-
Yep you can just buy the bits you need
try these guys for diagrams and part numbers http://www.roverparts.com.au/rear_su...scovery_31?b=1
I just replace whole assemblies because that is lighter on labour.
-
To buy the complete arm doesn't include the bush I need.
Is there any special tools, a press required to install the hub knuckle bush
I need?
-
Now that I've looked at the schematic, I get which bit that is ... here's the page from the online version of the service manual :
Land Rover Workshop Manuals > LR3/Disco 3 > 204-02 Rear Suspension > Upper Ball Joint(64.15.07)
Probably could improvise something to press it out and then back in or as you have to take the whole knuckle out, you could take it to a mechanic / machine shop or similar that has a press and away you go. Good luck !
-
Just had a look at the manual to remove the knuckle. Has any one done it
without special tools?
-
Hi Ade,
Don't feel bad.
I have a Kaymar bumper / rear wheel carrier with HF antenna mount and did the same as you. Took the trailer off and, didn't reset the LED module. Backed into a tree not taking a great deal of notice what I was doing and pushed the antenna mount into the rear window.:o:censored:
Too easy to do.
Good luck with your repair.
