Fuel Filler Flap will not open!

Should be able to get graphite powder from a locksmith ,that's where I got mine from.Kero

Graphite powder is good for dry key locks but no good at flushing out dust from door lock mechanisms, only lubricating after they are cleaned. I use silicon spray - IMO it beats WD40 hands down for cleaning and lubrication although unlike WD40 its not stocked everywhere.

Quote:

---

Originally Posted by BobD

Why would I think you were having a shot at me? I was just stating the facts in a joking way, not taking offence! I just don't use smiley faces and things because I am too old school. Docker River is where mine went wrong the first time and CRC was all I had.


Just a question for you. The CRC seems to wash out the dust and let everything close properly, since it is all full of dust like every grease point on your grader. Does graphite do that as well? The last time I used graphite was on my electric train set about 50 years ago and I haven't even seen it since. I can't remember how it worked.


Thanks for the tip. I might see if I can get some.

---

Hi Bob
With the greasing,dust sticks to the grease,but only the grease that is exuded from the joints,it cant travel thru the nipple into where the grease is lubricating.
For dry joints that need occasional lubrication,like mullboard slides,turntable and centre pin we use a dry film graphite.Its a spray paint that dries very quickly.Its a bit messy to use on vehicles,would be great for leaf springs etc.Its available from CAT parts sellers.
Graphite powder is available in a puffer bottle from any hardware store.
Andrew