New Jack option.

Quote:

---

Originally Posted by LandyAndy

I called into Rovertech yesterday,they had what looked to be a mini 2.5t trolley jack in a carry case,I think it was $130+GST,the card on it said a must for D3/D4/RRS owners.
Andrew

---

Gday Andy, are you able to get some more info on this at all. Pics/tech info would be handy.

I can't believe that LR doesn't have this properly sorted.

Quote:

---

Originally Posted by Tombie

If using the arm...

Set off-road height.
Place jack in position
Go into vehicle and select a lower height
Vehicle will lower and lift the wheel off the ground..

---

Still enough clearance under the wheel arch to get the wheel off and out?

Quote:

---

Originally Posted by RHS58

Still enough clearance under the wheel arch to get the wheel off and out?

---

Certainly is. Once it comes off the spigot it comes out easily..

Quote:

---

Originally Posted by Tombie

Certainly is. Once it comes off the spigot it comes out easily..

---

That's a neat trick then.

Quote:

---

Originally Posted by Chops

Gday Andy, are you able to get some more info on this at all. Pics/tech info would be handy.

I can't believe that LR doesn't have this properly sorted.

---

When I drop my D4 into Southerns,I will see if I can remember to call in and see Kevin again,will see what I can do.I want one too,stone cold broke after 2 weeks holidaying,Mr K Roo didn't help adding $550 to the holiday bill:(:(:(
Andrew

Quote:

---

Originally Posted by Tombie

If using the arm...

Set off-road height.
Place jack in position
Go into vehicle and select a lower height
Vehicle will lower and lift the wheel off the ground..

---

BFG,a couple of warnings need to be added here.Land Rover do not advise jacking from an arm,yes it works.
If you do this via the chassis rail it will give you more lift,emegency height.Try it the dash will guide you thru it;););)
Handy if you have no electronics or rods to lift to maximum off road clearance for a short time;);););););)
ENJOY
Andrew

Think you're confused Andy. My version doesn't raise the vehicle [emoji6]

Andy. Part of the LR warning should be to never use their plasticine scissor jack [emoji6]

So there is so many different versions of these jacks, different part numbers different measurements, different heads, I'm going back and forth between pages and it's driving me crazy.

Which is the right one to get, that fits under and lifts the vehicle enough to get a tyre off, the one that ✅ all the boxes❓
And where is the best place to get it from in Sydney ❓ or wether online is better option ❓

Cheers :)

Cheers, Babs :D Sent from my iPhone using Forum Runner

Apparently a 2t 2 stage hydraulic from blackwoods but i got the 10t because it has an even higher lift and it still won't lift off the chassis without jacking timbers.