Thread: Sticky Fuel Cap Cover

Have a read of this thread, has a few good tips:

http://www.aulro.com/afvb/d3-d4-rrs/...-not-open.html

I had success with a few sprays of a circuit board cleaner when mine got sticky with Cape York dust and it's been good since then. I used this because I was worried about damage to the releasing switch but it sounds like silicon spray is just fine.

But if yours is not excessively dirty/dusty there may be another issue.

Scott

Originally Posted by LRD414

Have a read of this thread, has a few good tips:

http://www.aulro.com/afvb/d3-d4-rrs/...-not-open.html

I had success with a few sprays of a circuit board cleaner when mine got sticky with Cape York dust and it's been good since then. I used this because I was worried about damage to the releasing switch but it sounds like silicon spray is just fine.

But if yours is not excessively dirty/dusty there may be another issue.

Scott

Thanks mate,

I'll see if I can find one of the products and give that a whirl.

I was a bit concerned about squirting anything in there, not knowing the set-up internally.

But sounds like it should be OK.

Cheers.