Printable View
If you can make a tool up to fit the profile of the bush you'll make life easy..
Laser Tools makes an On vehicle tool for that bush about $300 for the tool, plus $85 worth of bushes (does both sides)...
Since you'll do them every few years the tool is worth it...
I'm waiting on a Pickvant Jig/Tool - a bit more pricey at $1800 complete but it can do the entire vehicle...
Won't be long and my fronts will need changing.. And I have a trip I'm planning next year so will change them before then.
I'm leaning towards that, but want to know what size press ill need. If i can get away with 2T I'll build a little portable one so i can do them on the car.
Otherwise ill look at a 20T and then i can do bearings etc too.
Cheers
Dan
When I was recently at Advanced Factors,they were using a 20T press to push the Lemforder bushes into the lower control arms.
If you get this: you won't need a press..
http://lasertools.co.uk/product/6180
You won't even need to take the wheel off or remove the arm from the vehicle...