Page 4 of 8 FirstFirst ... 23456 ... LastLast
Results 31 to 40 of 72

Thread: 2014 D4 in Limp Mode

  1. #31
    LRD414's Avatar
    LRD414 is offline Super Moderator Subscriber
    Join Date
    Oct 2014
    Location
    Brisbane
    Posts
    3,737
    Total Downloaded
    0

    2014 D4 in Limp Mode

    Loose earth lead?

    There are two earth studs just in front of cranking battery box.

    There is also one behind the kick plate trim panel by the drivers foot. This one is used in the Traxide setup I have, so could be used for your DBS and be loose (factory earth cables are on it). Even if not used for DBS I guess it could be loose.

    What about your cranking battery negative lead? Shouldn't need to be touched but could have been. And the positive too.

    Scott
    D4 TDV6 MY14 with Llams, Tuffant Wheels, Traxide DBS, APT sliders & protection plates, Prospeed Winch Mount w/ Carbon 12K, Mitch Hitch & Drifta Drawers
    Link to my D4 Build Thread
    D3 2005 V8 Petrol
    Ex '77 RRC 2 door. Long gone but not forgotten.

  2. #32
    Join Date
    Feb 2014
    Location
    Sydney
    Posts
    96
    Total Downloaded
    0
    Hi Scott,

    Main battery terminals are tight. I will check behind drivers kick plate as you mentioned.

    My DBS was earthed on the body in the engine compartment. I have totally removed the DBS; so that is a non issue now.

    Thanks
    Brad

  3. #33
    LRD414's Avatar
    LRD414 is offline Super Moderator Subscriber
    Join Date
    Oct 2014
    Location
    Brisbane
    Posts
    3,737
    Total Downloaded
    0

    2014 D4 in Limp Mode

    On mine, the power cable to the rear uses the A pillar kick plate earth stud. So I would have to check this one even if the aux battery was disconnected. Yours may be different.
    D4 TDV6 MY14 with Llams, Tuffant Wheels, Traxide DBS, APT sliders & protection plates, Prospeed Winch Mount w/ Carbon 12K, Mitch Hitch & Drifta Drawers
    Link to my D4 Build Thread
    D3 2005 V8 Petrol
    Ex '77 RRC 2 door. Long gone but not forgotten.

  4. #34
    Join Date
    Feb 2004
    Location
    Williams West Aust
    Posts
    20,998
    Total Downloaded
    0
    Brad.
    Have you got an electric trailer brake controler??? Only ask as they have to be wired to Land rover specs,its way different from what a normal Auto Elec would consider.
    Andrew
    DISCOVERY IS TO BE DISOWNED
    Midlife Crisis.Im going to get stuck into mine early and ENJOY it.
    Snow White MY14 TDV6 D4
    Alotta Fagina MY14 CAT 12M Motor Grader
    2003 Stacer 525 Sea Master Sport
    I made the 1 millionth AULRO post

  5. #35
    Join Date
    Feb 2014
    Location
    Sydney
    Posts
    96
    Total Downloaded
    0
    Hi Andrew,

    No electric brake controller; it's my next install when I get the car sorted.

  6. #36
    Join Date
    Sep 2013
    Location
    Brisbane
    Posts
    807
    Total Downloaded
    0
    Rear aircon? What about the wires that run through under the rear aircon? If it's only on jolts maybe it's a bared wired touching something on the jolt ?

  7. #37
    Join Date
    Feb 2004
    Location
    Williams West Aust
    Posts
    20,998
    Total Downloaded
    0
    Quote Originally Posted by Bradmc View Post
    Hi Andrew,

    No electric brake controller; it's my next install when I get the car sorted.
    When you do,make sure you read the D4 trailer brake thread in the stikys up top.Some very important info there.
    Ive just tried towing with my Redarc Tow Pro,the trailer brakes are much more noticeable than behind the D2 which had a Technosha Prodigy.Very happy.
    Andrew
    DISCOVERY IS TO BE DISOWNED
    Midlife Crisis.Im going to get stuck into mine early and ENJOY it.
    Snow White MY14 TDV6 D4
    Alotta Fagina MY14 CAT 12M Motor Grader
    2003 Stacer 525 Sea Master Sport
    I made the 1 millionth AULRO post

  8. #38
    Join Date
    Apr 2008
    Location
    Brisbane,some of the time.
    Posts
    13,886
    Total Downloaded
    0
    Quote Originally Posted by Meken View Post
    Rear aircon? What about the wires that run through under the rear aircon? If it's only on jolts maybe it's a bared wired touching something on the jolt ?
    Someone else on here had an issue with the wires pinched near the rear AC,on a late model D4.

    The other thing you could do,is get the vehicle running stationary,with someone sitting in the drivers seat,and start wiggling every wiring harness accessible.
    Then if the fault comes up you may be able to pinpoint where the issue is.

    I know this is grasping at straws,but it may help locate the fault

  9. #39
    Join Date
    Feb 2004
    Location
    Williams West Aust
    Posts
    20,998
    Total Downloaded
    0
    Quote Originally Posted by scarry View Post
    Someone else on here had an issue with the wires pinched near the rear AC,on a late model D4.

    The other thing you could do,is get the vehicle running stationary,with someone sitting in the drivers seat,and start wiggling every wiring harness accessible.
    Then if the fault comes up you may be able to pinpoint where the issue is.

    I know this is grasping at straws,but it may help locate the fault
    Somebody bouncing the vehicle may also help too.
    Perhaps a friendly nearby D4 pilot could help with the research,it could help us all out into the future
    What area do you live in???
    Andrew
    DISCOVERY IS TO BE DISOWNED
    Midlife Crisis.Im going to get stuck into mine early and ENJOY it.
    Snow White MY14 TDV6 D4
    Alotta Fagina MY14 CAT 12M Motor Grader
    2003 Stacer 525 Sea Master Sport
    I made the 1 millionth AULRO post

  10. #40
    SBD4's Avatar
    SBD4 is offline A Keeper of the TGO Gold Subscriber
    Join Date
    Dec 2011
    Location
    Bundeena
    Posts
    2,809
    Total Downloaded
    0
    Perhaps try re-seating the fuses and relays - you never know. Also check what work was done on your last service, it might point you to an area they may have touched. The errors seem very "brake switchy" to me, check switch is properly positioned/plugged in - replace if in doubt, it's very cheap. What about wiring for the trailer plug? was that touched at all? could be a short back there.
    Cheers,

    Sean

    “Only two things are infinite, the universe and human stupidity, and I'm not sure about the former.” - Albert Einstein

Page 4 of 8 FirstFirst ... 23456 ... LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!