Fitting a used Mitch hitch

Printable View

13th July 2016, 05:03 PM
Ozzy119

Quote:

Originally Posted by Narangga

The rough join/edge on the recovery eye will need to be ground out to allow the bush to slide through.

I cursed the expense and bought a Dremel. However that meant it only took me less than half an hour to get the eye to be able to receive the bush.

I have also used the Dremel a number of times since - including on remote fob cases. :(

Does this require any rust inhibitor be applied to the surface to protect the frame ? Or a spray of paint or something similar ?

cheers
13th July 2016, 07:46 PM
Narangga

Quote:

Originally Posted by Ozzy119

Does this require any rust inhibitor be applied to the surface to protect the frame ? Or a spray of paint or something similar ?

cheers

Being cast I did not do anything to it. I had not read of anybody else doing anything like that to theirs either. HTH.
15th July 2016, 05:42 PM
Stealthylandy

Thanks for the post and helpful suggestions guys. Hopefully we will be fitting our SH Mitch hitch to our disco very soon... Then we'll finally be able to tow stuff!