Front LCA rear bush remover tool for loan! Central Coast NSW

Have you tried reducing those tyre pressure?

The ride may get even better,and wear on the vehicles suspension will be reduced.🙂

Point taken. They're a pretty soft compound MT (Atturo Trail Blade) and at 55psi are softer than my old 19s were. I vary the pressures a bit and tell myself they're quieter on the highway at higher PSI. If I'm honest, I'm concerned that the that their max load rating is at 80psi.. Leaves me wondering what they can carry at 18psi.. never rolled one off the rim but it's a concern... Apologies to the peeps who are reading this thread looking to borrow LCA bush removal tools. PM me if you're Gold Coast or Brisbane, I may still be able to help.

Quote:

---

Originally Posted by Dagilmo

Hi All,

I'm awaiting the arrival of the laser tool for front lower rear bushes. After I've done mine (a Christmas to New Year job) it will be available for Perth Disco owners under the same conditions as Dan has listed.

I've done a bit of searching (Dan's link not working for me) but I can't find any information on how to do the job. Looking at the car I guessing it's as simple as removing the bolts from the front bush, bottom strut bolt and the rear bush then drop down and use the tool. Can someone confirm or correct me?

Also torque settings when refitting nuts and bolts?

---

Dragging this thread up from the dead - just wanted to throw a thank you out to David for lending me his press tool. Also I've just ordered the front lower front bush laser tool and I'll also make it available to Perth people.