-
To rotate the free spool handle all you need to do is remove all but two hex bolts on that end cover. Loosen final two to the point of thread disengagement. Do not remove fully. The end cover can now be pulled out slightly (do not pull off completely) just enough to rotate the whole assembly to desired position. I put slight pressure on one of the remaining bolts so I could feel when it aligned with hole in new position. Screw at least one screw in to hold in place, replace all screws and tighten. Really simple, takes a couple of minutes.
-
4 Attachment(s)
Thanks Mungus, Yep rotating gearbox simple procedure.
I followed your mounting method for Control Box.
I looked at other options but this looks & works best.
I had to re locate my Fyrlyt Convertors as I originally located them were the winch sits, now one each side next to fog lights.
I wasn't planning on a winch at the time.
With the bar off, its much easier to sort this stuff out.
All ready to bolt back on tomorrow and connect.
-
3 Attachment(s)
Job Done.
I made a bracket to mount isolator on next to second battery.
Just a bit of steel flat bar, 150 x 60 x 3mm
-
It looks Great, Love your work Mate[thumbsupbig]
-
Bumper
-
Very nice work!
I like the over-head crane and work space. Was this a Runva option?[thumbsupbig]
-
Cheers
The overhead crane certainly made job easy on my own.
I was surprised how well and straight it hung, even with winch added.
[smilebigeye]
