Custom Install Driving Lights and Light Bar

Nice work. I love the tip about the dremmel and the different coloured zip ties.
The easiest option is probably just to replace that trim piece rather than attempt a repair.

Land Rover Discovery 4 RHD Driver Dash Trim End Cap Panel in Almond LR018515 | eBay

Cheers,
Scott

Good work - just one pointer; where you fed those red / green wires through - you need a grommet!!!

Those wires will cut through once offroad..

Quote:

---

Originally Posted by Tombie

Good work - just one pointer; where you fed those red / green wires through - you need a grommet!!!

Those wires will cut through once offroad..

---

I ran my uhf ariel cable thru that hole but i put a hole in the grommet and poked some 10mm alloy tube in it then fed the cable thru that keeping the grommet in place.

I have so much running through that grommet I’m about to switch to a Comms Bus system to
Reduce the amount of cables!

People like you Harrythedisco annoy me! That is one great set up. (And write up!) I wish I could do all that[emoji13]
My wife’s an accountant, maybe I could get her to do it[emoji14]
Well done!
Dave.

Quote:

---

Originally Posted by HarrytheDisco

Hi Trout

yes you can replace the original fuse which you have taped and add an additional fuse for the new circuit you are making.

---

I may have to get me some of those [bigsmile1]

Quote:

---

Originally Posted by LRD414

Nice work. I love the tip about the dremmel and the different coloured zip ties.
The easiest option is probably just to replace that trim piece rather than attempt a repair.

Land Rover Discovery 4 RHD Driver Dash Trim End Cap Panel in Almond LR018515 | eBay

Cheers,
Scott

---

Thanks Scott

I am perusing eBay as we speak for a decent condition replacement.

Quote:

---

Originally Posted by trout1105

I may have to get me some of those [bigsmile1]

---

They are very handy! Just be aware there is a 50amp limit (combined) on the fuses you can insert

Quote:

---

Originally Posted by Tombie

Good work - just one pointer; where you fed those red / green wires through - you need a grommet!!!

Those wires will cut through once offroad..

---

Thanks Tombie

I went back and filled that hole with some Selleys Knead It epoxy so hopefully that will keep the wires from moving around. Good tip though, I’ll keep an eye on it.

Quote:

---

Originally Posted by BrianElloy

those Stedi light bars sure are purdy!

---

They sure are Brian. And boy do they throw some light!