Filter in the compressor may be blocked or exhaust valve stuck.
Printable View
Filter in the compressor may be blocked or exhaust valve stuck.
90% of the time the gallery error is as LoanRangie says - the desiccant has turned to powder and blocked the filter in the canister - when it tries to reverse vent back through it can’t.
New desiccant and filters are available.
Pics 1-2 new boots for the old girl
255 55 19 inch
Local tyre power store reckons the Pirelli tyres were reduced from $450 each to $255 each x4 = $1020 fitted and balanced.
Also told me the Pirelli tyres are the top notch in tyres and a very good road tyre. Will see how they perform.
Wheel alignment not done due to my suspension issues - seems now the rear end goes into extended mode but on other drives all suspension issues resolve themselves even whilst driving - error codes disappear from view.
Today I had my car serviced and a remap with ERG motors switched off, pipes removed and blanking plates fitted. I am not that familiar with the bits around my motor. Can someone direct me where to look to see where the blanking plates are located, and where are the ERG motors. I thought they were on the air intake after the filter but I cannot see any cut wires etc, just wondering how they get switched off. TIA.
EGR outputs to the inlet manifold are just pipes either side of the inlet Y pipe.
The EGRs are on the exhaust manifolds down the sides of the motor. If you look closely you should see a blanking plate now up on the top of each exhaust manifold.
Wiring isn’t cut or removed unless the entire unit is unbolted (unlikely) - just disabled in the ECU
Looking at the tyre it seems the load rating is 107. If that is so it is incorrect as the minimum is 111