D4 GEARBOX FAULT P0928-13 GEARSHIFT LOCK SOLENOID - OPEN/CIRCUIT

Hi Guys, If the LCD on the dash is displaying "P" when in Park you'd assume the TCM is registering that its in Park. Having said that when I bought the disco 15,000ks ago the parking pawl wasn't working. The roller that the clicker runs on (in gearbox) was in the bottom of the pan, which I reinstalled and then did oil filter and pan conversion. Do you think the selector rod maybe not be moving the gearslider sensor in the TCM far enough to satisfy the gearshift lock? However it is displaying P when in park.

Yes, that’s what I’m thinking

Well turns out the TCM selector sensor was the culprit. I separated the TCM from the valve body and the inside of the slider was feral, will thow a pic on. The selector rod to park pawl was ok, it cant change the selector sensor as can only go in on position because the ****er clicker is fixed in one position. So thankyou guys I really appreciate your input.

Yay I win! I suggested the sensor (not knowing what the hell I was talking about)

Quote:

---

Originally Posted by DiscoJeffster

Yay I win! I suggested the sensor (not knowing what the hell I was talking about)

---

Youre on a roll DJ , first your engine's crank shaft end float now this. Where wil it end?

Quote:

---

Originally Posted by Eric SDV6SE

Youre on a roll DJ , first your engine's crank shaft end float now this. Where wil it end?

---

In a puddle of oil and metal on the side of the road most likely!

Now now, dont get discouraged. Theres always limp mode....:clap2: