The patch is required on the EU4 models. In my case it was built 11/07 MY08.Quote:
Originally Posted by Tombie
Printable View
The patch is required on the EU4 models. In my case it was built 11/07 MY08.Quote:
Originally Posted by Tombie
Mine is 01/08 and all was working fine, it was atleast 4 or 5 yrs ago that I tried it, still have the same egrs on the car and they were left connected , just used the plates and removed the butterfly. After about 2 weeks of varied amounts of limp mode faults I put them back and just clean the Y piece usually every oil change.Quote:
Originally Posted by loanrangie
Bulletman
I'm on EU4 and still no issues with only the plates fitted, if they weren't functioning or i had unplugged or removed them i'd need the patch - i may do in the future but been no issues in 11 months.Quote:
Originally Posted by BradC
Yes if the EGRs are fully functioning you do not need a patch when EU4 are blanked - no eml comes on. The issue is how long will the EGRs keep functioning when blanked - the patch gets around this.
In my car things are different and I have mentioned it before. Back in 2012 my EGRs failed, before patches etc. I had bought two new EGRs at a very good price but when I looked at what a pain it was to put them in I just blanked the system and of course that was OK except the EML stayed on but the car ran fine.
In tinkering around I plugged the new EGRs into the wiring harness with the old EGRs still connected to the exhaust. Car ran fine and eml went out.
So nearly 8 years later, the original broken EGRs are still connected to the exhaust, the system is still blanked and I have two brand new EGRs sitting in the ABS box in the engine bay, plugged into the EGR wiring loom. They open and close as directed by the ECU and send the right signals back to the ECU. The cost of the EGRs were about half the cost of the subsequent electronic patches, I saved my knuckles from having to put in new EGRs and it all works perfectly and with EML or codes.
Garry
Got a reply from Pete @ BAS.
Need to fit the blanks and load the firmware patch to delete the EGRs
Blanking plates are cheap, not sure if its something I can tackle but will have a look.
The firmware patch is 150 GBP ouch https://www.aulro.com/afvb/images/icons/icon8.png
If you get the ones with the slots you can loosen up the bolts, slide the plate in above the gasket and tighten them back down.Quote:
Originally Posted by PeterOZ
Originally I put a gasket on both sides of the plate to mitigate boost leakage from the top which made it a bit tighter and necessitated removal of the bolts to get the gasket in.
It's not difficult, just fiddly. I eventually ended up "losing" the pipework and just fitting covers to the EGR valves.
If you want to give it a go ,i can send you a pair of plates.Quote:
Originally Posted by PeterOZ
that would be much appreciated! Thank youQuote:
Originally Posted by loanrangie
So I had a quote from Bunbury Fuel Injection for 500 bucks to "service" egrs. Basically adding blanking plates and map them out. Seems reasonable, but if I could DIY that would be better. I like the idea by 101RRS, just not sure if this would work on a D4.Quote:
Originally Posted by loanrangie
How do you know if it's EU4?Quote:
Originally Posted by BradC