I've thought about it a lot. I love my D3, but the D4 has all sorts of extra nice stuff. The problem is getting a D4 with 3 pedals. They don't exist except as a base model industrial in the UK.
MY08 D3 - The Antichrist - "Permagrimace". Turn the key and play the "will it get me home again" lottery.
A few things to consider
D4 is arguably the best 4 wd available
the rear axle load limit is a issue if towing
the engine can die any time , fingers gets crossed for mine
they are much cheaper then any other option so that difference can pay for considerable repairs and maintenance
all older 4wds cost a lot to maintain, check out the cost of a set of injectors for a 200…
Discovery 1 4.6, true trac front and rear, superior engineering arms,old tourer now bush toy
Discovery 4 3.0 HSE MY13 ECB Bull bar, winch, spot lights, aux fuel tank, Kaymar rear bar, duel wheel carriers, 18 tuff ant wheels 265/65/18 BFG KO2's for play
I would only buy a D4 if i had a 2.7 long block on a stand ready to go and would fit it myself.
MY08 TDV6 SE D3- permagrin ooh yeah
2004 Jayco Freedom tin tent
1998 Triumph Daytona T595
1974 VW Kombi bus
1958 Holden FC special sedan
The issues with the 3.0 has put me off progressing to the D4. The crank failures are just too random for my liking.
I would go with either the 2.7, the 5.0, or only go with a 3.0 if it was a recently installed new replacement engine sourced from JLR. I would be very wary of a rebuilt engine.
Pretty rare to need a full set,unless it has done350 to 400,000Km,and been serviced properly.
The neighbours had one that did 360,000Km,6 yrs old,a heap of dirt road Ks,not one repair.Traded on a new one,12 months ago.
Most of the services done by themselves,the rest done at the dealer at St George.
Stock with just a bar and side rails.
Their LC300 has already had the 7th injector,which is for for the DPF, needing an extra clean or something along those lines.
It brought up a fault code.
Has anyone yet to try the cheap replacement engines from Ali Express or know anything about them.
So i found out from the internet that the oil pressure is supposed to be:
0.5-1 bar at idle
1.9 bar at 2500 RPM
3.4 bar at 3500RPM
Is this correct? Just so I know what to check for. And assuming the oil pressure hit these numbers, the engine should be in fairly good condition?
Cheers,
Christian
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks