Results 1 to 6 of 6

Thread: Tailgate noisy and vibrates

  1. 11th February 2026, 09:22 AM #1
    JEROME
    JEROME is offline Member
    Join Date
    Feb 2026
    Location
    Brisbane
    Posts
    1
    Total Downloaded
    0

    Tailgate noisy and vibrates

    Hi !
    Would anyone know how to adjust the tailgate ? It rattles when driving on bumpy tracks and is so annoying :-(
    Is this a common , known issue ? Just purchased my Disco4 SDV6, 180,000km, 2015 HSE.
    Reply With Quote Reply With Quote
  2. 11th February 2026, 09:39 AM #2
    DieselLSE's Avatar
    DieselLSE
    DieselLSE is online now Wizard Subscriber
    Join Date
    Nov 2015
    Location
    Black Rock
    Posts
    1,277
    Total Downloaded
    0
    Most unusual. I wonder if there's been an accident repair. It will be adjustable, when I have a few minutes I'll take a look.
    2013 D4 expedition equipped
    1966 Army workshop trailer
    (previously SII 2.25 swb, SIII 2.25 swb & lwb, P38 Vogue, 1993 LSE 3.9V8 then HS2.8)
    Reply With Quote Reply With Quote
  3. 11th February 2026, 09:54 AM #3
    DiscoJeffster
    DiscoJeffster is offline TopicToaster Subscriber
    Join Date
    Mar 2016
    Location
    Perth
    Posts
    4,421
    Total Downloaded
    0
    Quote Originally Posted by DieselLSE View Post
    Most unusual. I wonder if there's been an accident repair. It will be adjustable, when I have a few minutes I'll take a look.
    Yeah like all latches, the lock/latch receiver will likely be adjustable to bring more clamping. Agree, not heard of ever.
    2010 TDV6 3.0L Discovery 4 HSE
    2007 Audi RS4 (B7)
    Reply With Quote Reply With Quote
  4. 11th February 2026, 10:24 AM #4
    PerthDisco's Avatar
    PerthDisco
    PerthDisco is offline ChatterBox Subscriber
    Join Date
    Oct 2012
    Location
    Perth
    Posts
    2,784
    Total Downloaded
    0

    Tailgate noisy and vibrates

    Quote Originally Posted by DiscoJeffster View Post
    Yeah like all latches, the lock/latch receiver will likely be adjustable to bring more clamping. Agree, not heard of ever.
    Yes, if you remove the shroud around the upper tail gate ‘eye’ it can be adjusted to apply more pressure on the rubber stops. It’s a bit tricky to adjust. I adjusted it pretty tight and left the two bolts slightly loose then closed it to allow some settling. Then tighten it fully. Might take a few goes. Too tight it’s hard to close too loose it vibrates and it’s a very annoying rattle.
    Reply With Quote Reply With Quote
  5. 16th February 2026, 08:31 PM #5
    veebs's Avatar
    veebs
    veebs is offline Wizard Subscriber
    Join Date
    Oct 2016
    Location
    Perth, AU
    Posts
    1,022
    Total Downloaded
    0
    It’s not your number plate rattling is it?
    2010 TDV6 3.0L Discovery 4 SE remapped to RRS output, Alaska White, GME XRS-330c, IIDTool BT, Dual Battery, Apple CarPlay, OEM Retrofitted: Cornering lights, Door card lights, Power + Heated Seats, Logic 7 audio
    Reply With Quote Reply With Quote
  6. 17th February 2026, 08:49 AM #6
    ytt105
    ytt105 is offline Master Supporter
    Join Date
    Jan 1970
    Location
    NSW Far South Coast
    Posts
    689
    Total Downloaded
    0
    Check the lower tailgate catches. The bolts on the side that the catch 'catches' on were slightly worn and hence there was a continuous rattle. I gave up trying to adjust the rattle out and just wrapped some electrical tape around them. Rattle now gone!

    PS. Just thought, I wonder if swapping the bolts from one side to the other might fix it as the stricking/wear points would be different.
    Reply With Quote Reply With Quote
« Does my 2016 LR Discovery TDv6 need a new timing chain? | D4 AC Intermittently Cold – Compressor Clutch Engaging, Recently Re-Gassed (MY13 SDV6 »

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!