get a mitch hitch.
i did.
Hi all,
have recently purchased a 2007 RRS that had a factory quick fit tow bar hitch to it (the one with the green handle and key). it came with a tongue that has genuine land rover stamped on it. part number RAA500.
when i slot that in, it sits very very low, probably 15-20mm off ground. far too low to attach anything and i sure it would scrape going in and out out driveway. a bit of research tells me this is a "goose neck" tongue.
has anyone else had this problem? or can canyone tell me if there is a tongue that is different that will slot into the hitch?
or do i need to go to a tow bar shop and purchase an aftermarket tongue?
there is no way i could tow anything with it currently .
thanks
get a mitch hitch.
i did.
It sounds as though you have the tongue stepped down rather than up.
MY12 RRV 4.4 TDV8 AB, +LLAMS, +e-diff, +ACC stop/go. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi
I've never encountered any reason not to flip it as required. I don't place any significance in the plate's position.
MY12 RRV 4.4 TDV8 AB, +LLAMS, +e-diff, +ACC stop/go. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi
Here ia pic I just took of mine. PN RAA550 (not RAA500) With the label up the ball is 450mm off ground (EAS normal height)
Here is some info I found on correct tow ball heights
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks