Results 1 to 3 of 3

Thread: 2008 L322 Brake Controller Install

  1. 22nd February 2023, 05:52 PM #1
    BusinessConnected
    BusinessConnected is offline Master Supporter
    Join Date
    Feb 2010
    Location
    Melbourne
    Posts
    337
    Total Downloaded
    0

    2008 L322 Brake Controller Install

    Good Evening:
    I've just got my L322 2008 TDV8 back and working after Intake Manifold Replacement.
    Looking at fitting a Brake Controller and had some wishful thinking regarding some connectors etc with the D3/D4 and other L322 overseas possessing a connector above the Brake Pedal for a Ford Based Brake Controller to plug in.

    So I have the Tekonsha P3 Brake Controller and the 3035-P but after pulling apart under Steering Wheel/Brake Pedal area I'm not seeing a likely connection area.

    Has anyone fitted these previously... Do I need to complete a Full Wiring Loom instead?
    Reply With Quote Reply With Quote
  2. 6th June 2023, 01:16 PM #2
    harlie's Avatar
    harlie
    harlie is offline Wizard Supporter
    Join Date
    Jan 1970
    Location
    Manly QLD
    Posts
    1,452
    Total Downloaded
    0
    I'm a bit surprised you didn't get an answer - hope you got it sorted by now but for completeness....

    There is no factory wiring harness to hook into unfortunately. The brake light switch on the pedal is hall effect so you can't pick it up there - you need to pickup the brake light signal at either the Light Control Module (driver's footwell, throttle pedal side for us RHD) or at the rear coming out of the Trailer Light module. If you get a signal at the front, I recommend tapping the brake light signal coming out of the Light Control module that feeds the trailer lights as apposed to the line feeding the car's brake lights.
    L322 3.6TDv8 Lux
    Reply With Quote Reply With Quote
  3. 6th June 2023, 01:28 PM #3
    BusinessConnected
    BusinessConnected is offline Master Supporter
    Join Date
    Feb 2010
    Location
    Melbourne
    Posts
    337
    Total Downloaded
    0
    I ended up going the Electric Brake Controller for the Trailer instead.
    Was easier and simpler than messing around with Land Rover wiring etc..

    Ended up being a wise decision now the Range Rover TDV8 Appears to have blown up and is cactus..
    Reply With Quote Reply With Quote
« Loss of low range TD6 | TDV8 Engine Issues etc »

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search AULRO.com ONLY!
 Search All the Web!