Reply With QuoteI've had it out but didn't have any problems. I can't remember how.
Swaggie
I've removed the 4 bolts but the outer front post or bolt is preventing the tray from being lifted at the front, although the rear can be lifted which appears to swivel the front downwards. Any suggestions?
I need to remove the tray to repair the battery monitor wiring that has been chewed off.
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
Major part of the heart and soul of AULRO.comI've had it out but didn't have any problems. I can't remember how.
Ron B.
VK2OTC
2003 L322 Range Rover Vogue 4.4 V8 Auto
2007 Yamaha XJR1300
Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA
RIP Bucko - Riding on Forever
Swaggie
Thanks Ron for responding.
The stubborn stud is stubborn because it has a nut holding a bracket for the FFH which can only be undone via the wheel arch after removing the liner. I'll have to put up with the charging system fault until I have more time to again remove the battery and then the wheel and liner once I can find it under the mud.
I managed to scrape the insulation from a wire in a bundle at the front of the tray but separating the wires revealed only 1 wire damaged so re-taped the bundle.
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
Master
SubscriberGraeme
There is another bolt/clip under the tray, you get access by removal of the wheel splash cover, I believe.
Laurie
I see we posted about the same time Graeme
2010 TdV8 Autobiography, D2 Td5, RRC 4 Door VM/300Tdi, RRC 2 Door V8
Major part of the heart and soul of AULRO.comI don't remember doing that.
Ron B.
VK2OTC
2003 L322 Range Rover Vogue 4.4 V8 Auto
2007 Yamaha XJR1300
Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA
RIP Bucko - Riding on Forever
Wizard
Have had my battery tray out a few times.
All I had to do was undo the tray bolts , then lift it out.
It might be slightly different on the later models tho.
DG
2014 Freelander SE TD4
2003 Range Rover TD6
92 disco tdi manual sold
95 disco tdi auto gone
Swaggie
Yes, MY10+ tray has a stud for the FFH bracket whereas earlier models had a bolt from the top and a nut underneath that appears to be accessible from the top. I now plan to drill out the top of the stud rather than go in from underneath and fit a suitable bracket for the FFH so that the tray can be easily removed from the top.
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
Major part of the heart and soul of AULRO.comFFH?
Ron B.
VK2OTC
2003 L322 Range Rover Vogue 4.4 V8 Auto
2007 Yamaha XJR1300
Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA
RIP Bucko - Riding on Forever
Swaggie
Fuel fired heater, commonly called fuel burning heater.
MY21.5 L405 D350 Vogue SE with 19s. Produce LLAMS for LR/RR, Jeep GC/Dodge Ram
VK2HFG and APRS W1 digi, RTK base station using LoRa
Major part of the heart and soul of AULRO.comAha! I knew it as FBH.
Are they fuelled by petrol in a petrol vehicle and diesel in a diesel vehicle?
Ron B.
VK2OTC
2003 L322 Range Rover Vogue 4.4 V8 Auto
2007 Yamaha XJR1300
Previous: 1983, 1986 RRC; 1995, 1996 P38A; 1995 Disco1; 1984 V8 County 110; Series IIA
RIP Bucko - Riding on Forever
| Search AULRO.com ONLY! |
Search All the Web! |
|---|
|
|
|
Bookmarks