Page 1 of 4 123 ... LastLast
Results 1 to 10 of 35

Thread: Caravan electrical connections

  1. #1
    Join Date
    Nov 2018
    Location
    Melbourne
    Posts
    5
    Total Downloaded
    0

    Caravan electrical connections

    Have just taken delivery of our td6 HSE and looking to get it ready to tow our caravan. A MY 18 built dec 17.

    What is the wiring configuration of the factory supplied 12 pin connector? Dealer cannot tell me.

    Auto elect said it also needs an adaptor to enable the vehicle towing system to detect when the van is connected because the van has LED lights which apparently may not draw enough current for the disscovery to detect when the van is connected.

    Any experience feedback would be helpful

    Thanks

  2. #2
    Join Date
    Jan 1970
    Location
    Pennant Hills, Sydney
    Posts
    1,415
    Total Downloaded
    0
    There is some good info on trailer plug wiring at the top of this section, I am still waiting for my TD6 HSE Lux was held up due to changes in the emission testing by the government so hopefully rocking up soon as I am also going to wire up a brake controller cradle which will take my Tekonsha controller.

    Ordered the 3035-P wiring kit so this should get it working.

    Also so on list is Dash cam and dual battery.
    disco seriesII mods so far:-bullbar,hyd winch,
    detriot locker,lsd front,C.D.L kit,chipped and bigger intercooler,2" lift,rock sliders, lsd in transfer case, modified auto trans.

    In the event of nuclear war,Disregard this message

  3. #3
    Join Date
    Oct 2011
    Location
    Hunter Valley
    Posts
    513
    Total Downloaded
    0
    If I were you I would check that your car detects the trailer with LED lights. Mine is a MY18 and it does detect a trailer with LEDs, so no need to add resistors. This does not appear to work on MY17 models however there is someone on the UK forum with a MY17 that also correctly detects a trailer with LEDs.
    So before spending any money, check it out.

    Ron
    2016 D4 TDV6 Corris Grey
    --------------------------------------------------------
    2018 D5 TD6 SE Silicon Silver - gone
    2011 D4 TDV6 2.7 Indus Silver - gone
    IIDTool BT

  4. #4
    Join Date
    Nov 2012
    Location
    Annandale, Sydney
    Posts
    101
    Total Downloaded
    0
    Ours is a 2017, apparently MY16.5, and it is fine with the LEDs on our van.
    Tony

  5. #5
    Join Date
    Oct 2011
    Location
    Hunter Valley
    Posts
    513
    Total Downloaded
    0
    Did they do a MY16.5 D5 ?
    2016 D4 TDV6 Corris Grey
    --------------------------------------------------------
    2018 D5 TD6 SE Silicon Silver - gone
    2011 D4 TDV6 2.7 Indus Silver - gone
    IIDTool BT

  6. #6
    Join Date
    Nov 2012
    Location
    Annandale, Sydney
    Posts
    101
    Total Downloaded
    0
    That’s what it says

  7. #7
    Join Date
    Oct 2011
    Location
    Hunter Valley
    Posts
    513
    Total Downloaded
    0
    Ok, interesting to see that your 2017 car does recognise the trailer, as many don't.
    2016 D4 TDV6 Corris Grey
    --------------------------------------------------------
    2018 D5 TD6 SE Silicon Silver - gone
    2011 D4 TDV6 2.7 Indus Silver - gone
    IIDTool BT

  8. #8
    Join Date
    Nov 2012
    Location
    Annandale, Sydney
    Posts
    101
    Total Downloaded
    0
    I take it all back IndusD4! Mine doesn’t read the van, but it will soon!
    Tony

  9. #9
    DiscoMick Guest
    Does yours need a separate Anderson plug to connect to the battery charging system in the van, or does it also go through the 12 plug?
    On our Defender the bottom six plugs are standard trailer wiring and also work on our box trailer, however the charge for the camper battery goes through a 7th plug on the top row.
    Some caravans come with a separate Anderson plug for the battery charging.
    Your sparky should know.

  10. #10
    Join Date
    Nov 2012
    Location
    Annandale, Sydney
    Posts
    101
    Total Downloaded
    0
    Quote Originally Posted by DiscoMick View Post
    Does yours need a separate Anderson plug to connect to the battery charging system in the van, or does it also go through the 12 plug?
    On our Defender the bottom six plugs are standard trailer wiring and also work on our box trailer, however the charge for the camper battery goes through a 7th plug on the top row.
    Some caravans come with a separate Anderson plug for the battery charging.
    Your sparky should know.
    I have a separate plug for charging the van batteries through a Redarc M30. I need resistors in the indicator and brake light lines to meet LR’s specified resistance.
    Tony

Page 1 of 4 123 ... LastLast

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!