Results 1 to 2 of 2

Thread: Fitting driving lights

  1. #1
    Join Date
    Jan 1970
    Location
    Pennant Hills, Sydney
    Posts
    1,415
    Total Downloaded
    0

    Fitting driving lights

    Well bought some lights and have started to fit them, 1st picture is the cutting guides, measured 3 times then cut, 2nd picture is the hole in grill, fitted the lights then removed the grill to get wiring right. 3rd picture I have glued the wire to the inside of grill to run it to the right hand side, 4th and 5th picture is them fitted to the grill and back on car. next part is connecting the canbus module to operate the relay for the lights.

    Will add that later on in week
    Attached Images Attached Images
    disco seriesII mods so far:-bullbar,hyd winch,
    detriot locker,lsd front,C.D.L kit,chipped and bigger intercooler,2" lift,rock sliders, lsd in transfer case, modified auto trans.

    In the event of nuclear war,Disregard this message

  2. #2
    Join Date
    Jan 1970
    Location
    Pennant Hills, Sydney
    Posts
    1,415
    Total Downloaded
    0

    Wiring all done

    As title says wiring all done, the 1st picture shows the location of the canbus wiring, side panel beside accelerator pedal, remove tread plate as there is a bolt to undo before removing panel also helps to pull door seal away from that area too.
    there are 4 wires with the colours needed 3rd pic shows the canbus pick up with cover removed the wires run along white lines the removed cover has the wire guides to get this done.
    4th pic is with cover on with wires running to the second unit which runs the relay in the 5th pic, last 2 shows a trailer plug wiring loom that i have run through the firewall with a Deutch plug only used 2 of the 7 wires drilled a hole in the rubber grommet above the steering wheel shaft about 30 mm from top of grommet, so now have spare wires for future possible projects. will post pictures of the lights once this bloody lock down is over.
    Attached Images Attached Images
    disco seriesII mods so far:-bullbar,hyd winch,
    detriot locker,lsd front,C.D.L kit,chipped and bigger intercooler,2" lift,rock sliders, lsd in transfer case, modified auto trans.

    In the event of nuclear war,Disregard this message

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!