IamKong
A few items specific to p38a to check out along with the usual 2nd hand car routine. This was taken straight from RangeRovers.net
ITEMS TO INSPECT PRIOR TO PURCHASE
The Mark II/P38 models are just as subject to leaks as the Classic models. Coolant leaks are not uncommon, including thermostat housing, hose leaks. Head gasket leaks seem to be especially common on the later model years. Popular oil leak points include the crankcase pan and the pinion seals. There were several recall campaigns on the earlier models, including one to address coolant leak problems; make sure the work was done. See if the Message Center indicates any faults when you turn on the ignition; this gives a good indication as to whether all the electrical and electronic features are operating. Make sure all the electric door locks work. Check the function of the air suspension (see above) and climate control. For the latter, just punch the "Auto" button and set the desired temperature, making sure the system heats or cools properly. Check out the items mentioned in the Common Issues and Repairs section.
THE TEST DRIVE
The Mark II/P38 should feel tight and car-like to drive, with reduced body roll, and virtually none of the clonking, slop and gear noise associated with earlier models. Steering should be precise and the car should track straight. Transmission shifts should be very smooth. Engaging "sport" mode by pressing the button next to the shifter should make the tranny stay in its lower ranges longer and shift down more readily. The torque converter lockup is electronically controlled and can tend to hunt to and fro a bit on hills, giving the impression of frequent gear changing. To test the transfer case, stop, select neutral, move the shifter across to the low range neutral position, wait 'til the beeps and flashing lights stop, then select the desired gear ratio. To test the climate control, just punch the big "auto" button and set the desired temperature.
Air Suspension: To test the air suspension, you need to know that it will only respond to commands if the engine is running, all doors and the tailgate are closed, and your foot is off the brake. In Park, you should be able to raise and lower it over the full range from "access" to "high" settings. In motion, if the "inhibit" switch (to the right of the height control switch) is off, the suspension should stay in standard profile until you exceed 50 mph for about 30 seconds, then it should lower itself to "low" profile. When you slow down below 35 for about 30 seconds it should revert to "standard". Below 35 mph you should also be able to select "high" profile.
Good luck with the searching
Gary


Reply With Quote

) and for every bug, there is generally a DIY fix for a fraction of the "PAYG" work$hop charge. Seriously, I suggest you spend a couple of hours looking through this reference and get a good idea of where things are at....

Bookmarks