Thread: P38A Drawer set up

Originally Posted by Robsrod 58

Phantom,

How did you secure the drawer system the car? I do like the finish of what you have done

This is what I did for the dual battery setup, making use of an otherwise vacant area.

Bloody hell that's neat. Impressed. Please do tell.

Thanks for that Shaun?,

The battery compartment contains a 100ah agm battery charged by a Redarc 6A DC-DC charger with circuit breakers protecting every thing. I run everything of this, compressor, drawer lights, fridge, rear work/reverse light and awning lights, also an input for solar.

Its all held together with 10mm booker rod which is attached to ribbing in behind the original lining. You can see the nut covers either side of the charger assy. the nuts hold the battery cover in place which is made of mdf and covered with the same material as the drawers.

When I get the car back from the bride I'll take some photos with the cover off and post them for you.

Rob

Originally Posted by Robsrod 58

Phantom,

How did you secure the drawer system the car? I do like the finish of what you have done

This is what I did for the dual battery setup, making use of an otherwise vacant area.

Very well done Rob, it must be a P38 Thing for us all to just go that bit tidier than average setup
I am thinking of the Ark pack to fit into same spot for Accessories etc that way it is also removable but who knows might end up with something similar to what you've done.

As far as my drawers & slide fixings, the fridge slide is fixed to the mounts for the rear seat I removed. Cant be seen in pics as carpet is cut around bolt head as a flap that can be lifted for access to remove/install as needed.
Drawer still to be fixed. This should be done soon.