Hello gents, well...new fuse box, pulled pump apart and refixed brass bush in housing, changed out piston to one with a better seal , found a dozen air leaks and charged battery...found to be biggest issue next to front left sensor reading way out. Heat shield missing so made a new one and swapped out level sensor. Now, EAS on , pump on...push standard height and off she goes. Having to pump up manually, but will go up and down to heights I set....still no engine. Pistons should arrive this week at rimmers then post to hear. Rebuilt valve block as well. I have a rescue kit on my old rangie that I will swap, will do whole EAS if have drama once engine is in and running. Thanks to all for advice. I will put pic of sensor readings and settings for heights I put in..it's about 10-15mm above where it should be I think. Let me know if I'm too far away.
Swapped sensor at front drivers side. It had a heat shield missing so made a new one...another problem solved. New engine being built as I write so hopefully all together in next month or so.
Search AULRO.com ONLY! |
Search All the Web! |
---|
|
|
Bookmarks