V8 county ute

The ARB compressor mounting bracket is not my favourite design, I understand why it is built like that, but it is very tedious to remove where I have placed it.
So I fixed it to a piece of 5mm sheet with some countersunk screws.https://uploads.tapatalk-cdn.com/201...e69b6e66ab.jpg
And installed some nurserts so I can fix from underneath https://uploads.tapatalk-cdn.com/201...e6f561f6c3.jpg
Tidied up the wiringhttps://uploads.tapatalk-cdn.com/201...aebcd14158.jpg
Put a divider in the storage bin https://uploads.tapatalk-cdn.com/201...d16a67a39c.jpg
With some holes for air to pass.
https://uploads.tapatalk-cdn.com/201...c070b3e406.jpg
An ally grill will feed air from the tray spacehttps://uploads.tapatalk-cdn.com/201...bc41cf2256.jpg
This will keep the water out when no tonneau.
I’ve been thinking about a small lawnmower type air filter behind the grill, but won’t overcomplicate it just yethttps://uploads.tapatalk-cdn.com/201...9b07b64039.jpghttps://uploads.tapatalk-cdn.com/201...4f966e6c20.jpghttps://uploads.tapatalk-cdn.com/201...1f15bbdf64.jpg

https://uploads.tapatalk-cdn.com/202...bc2aef2268.jpg
Due to unfortunate circumstances, which I may elaborate on later, I am subcontracting some work out on the ute.
It is off to Les Richmond Automotive https://uploads.tapatalk-cdn.com/202...7d906277bf.jpg

Who will fit a Haltech ecu
https://uploads.tapatalk-cdn.com/202...daa0048290.jpg
My 35 spline Arb locker Sals.

Chase down a rattle on over run in the transfer case.

And depending on how the funds go, I’ve got a few more things on my wish list.

Will be interested to see how the haltech conversion goes. Keep us informed...

Well I have yet to drive or see the car but I’ve just been sent the dyno sheet.
🥁🥁🥁🥁🥁🥁
https://uploads.tapatalk-cdn.com/202...a8d1c6dad4.jpg
I was hoping for 100kw .
The torque figure is impressive though.