Page 1 of 39 12311 ... LastLast
Results 1 to 10 of 385

Thread: V8 county ute

  1. #1
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0

    V8 county ute

    My first landy was a11a workshopimage.jpg

  2. #2
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0
    Then I got one of these
    And then did a bit of this with it.
    Until it was broken.

  3. #3
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0
    Then I bought this
    Here it is with the others
    Last edited by p38arover; 5th July 2017 at 07:26 AM.

  4. #4
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0
    Seeing as I already have a wagon and a dual cab work ute I might build a ute. With a bit of inspiration from rovercare's effort I have had the engineer visit so let the fun begin.

  5. #5
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0

  6. #6
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0
    A bit of my inspiration and where I'm heading

  7. #7
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0
    The car is a 1985 v8 county with 485,000 k's, I bought it about 3 years ago and swapped most of the drivetrain from the Rangie into it.
    As it sits now it has
    3.5 rv8 with 14 cux
    Zf auto
    Lt230 with 1.4:1 high and 30% maxidrive low range
    Laminated front housing with rotated swivels and maxi locker and early range 2 piece cv's, 110 brakes
    Open Sals rear with drums,

  8. #8
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0

    V8 county ute

    Thanks to lands864 I got this
    I also had one of these off the 2a

    A test fit
    Last edited by p38arover; 5th July 2017 at 07:27 AM.

  9. #9
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0
    I'm going to keep the B pillar and have made up another B pillar shaped infill piece to extend the cab 100 mm

  10. #10
    Join Date
    May 2009
    Posts
    981
    Total Downloaded
    0
    I needed to straighten it out after the heat
    Then add some crush tubes

Page 1 of 39 12311 ... LastLast

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Search AULRO.com ONLY!
Search All the Web!