-
1st December 2016, 07:13 PM
#1
V8 county ute
My first landy was a11a workshopimage.jpg
-
1st December 2016, 07:29 PM
#2
Then I got one of these
And then did a bit of this with it.
Until it was broken.
-
1st December 2016, 07:32 PM
#3
Then I bought this
Here it is with the others
Last edited by p38arover; 5th July 2017 at 07:26 AM.
-
1st December 2016, 07:35 PM
#4
Seeing as I already have a wagon and a dual cab work ute I might build a ute. With a bit of inspiration from rovercare's effort I have had the engineer visit so let the fun begin.
-
1st December 2016, 07:43 PM
#5
-
1st December 2016, 07:47 PM
#6
A bit of my inspiration and where I'm heading
-
2nd December 2016, 06:01 AM
#7
The car is a 1985 v8 county with 485,000 k's, I bought it about 3 years ago and swapped most of the drivetrain from the Rangie into it.
As it sits now it has
3.5 rv8 with 14 cux
Zf auto
Lt230 with 1.4:1 high and 30% maxidrive low range
Laminated front housing with rotated swivels and maxi locker and early range 2 piece cv's, 110 brakes
Open Sals rear with drums,
-
3rd December 2016, 04:25 PM
#8
V8 county ute
Thanks to lands864 I got this
I also had one of these off the 2a
A test fit
Last edited by p38arover; 5th July 2017 at 07:27 AM.
-
3rd December 2016, 04:54 PM
#9
I'm going to keep the B pillar and have made up another B pillar shaped infill piece to extend the cab 100 mm
-
3rd December 2016, 04:56 PM
#10
I needed to straighten it out after the heat
Then add some crush tubes
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Search AULRO.com ONLY!
|
Search All the Web!
|
Bookmarks